An explosive device without explosives

[Forgot My Fuckin Password]

First Things First:
I will not be held liable or responsible for any damages, losses, injury,
or death (intentional or accidental) which may occur from your
construction and/or operation of this device.
This post is for informational/educational or entertainment use only.
If you do not agree with this, then stop reading this post right now!

Here is the general design:

 .......
    :
   : :
   : :
   : :                                  ..................
   : :..................................:................:
 .......                     
                                               
   ^                  ^                        ^
 PUMP                AIR                    SEALED
                    TUBING                 PVC  PIPE

I hope that sketch displays correctly over your monitor, because it wasn't easy to get it to display right on my monitor.
SO if the sketch is out of alignment, then it's either my browser or your OS.

The design itself is so easy that I'm surprised with the number of people
who rely upon modern explosives and chemicals to build a bomb.
Maybe it is a result of CIA run sites like this one brainwashing people into
thinking that they "need" to buy "traditional" bomb making materials.
After all, it would only make sense (or should i say cents?) for federally
sponsored websites to promote the sale of semi-easily-traceable chemicals
to would be bombers (like you) while promoting the monopolized corporations
who pay for the federal permits to manufacture the stuff.

The sketch above in the code tag should be simple enough to figure out
if your system renders the message the same way my system renders it.

But I'll spell it out for you, step by step, just in case the sketch is skewed.

Get yourself a tire pump and replace the short length of air line
with some extended Heavy Duty air hose.
The pump can be one of the old hand pumps, but a heavy duty electric pump
might work just the same, except the detonation will come about a-lot faster
with the electric/battery powered pump.

Take a length of PVC tubing, 2 PVC End Caps, PVC Primer & Glue.
Install a threaded (bolt on) tire valve in of the end caps and make sure to
use plenty of glue for a secure seal.
Just drill a hole in one of the caps, add primer and glue, and then bolt the
valve stem into place.

Next glue the end caps onto the PVC pipe using the PVC Primer and PVC Glue.

Let dry for 48 hours (or longer).

Now put your explosive device in the location you'd like to detonate it in and
start pumping until an explosion occurs.

Now let me stress that I will not be held liable or responsible for any damages,
losses, injury, or death (intentional or accidental) which may occur from your
construction and/or operation of this device.

[warbeast]

awesome idea bro